Summary of an article published on The Web Scraping Club on 2026-07-19 (free to read). Read the full article

You launch a scraper on a heavily protected e-commerce site and it gets blocked within minutes. A datacenter pool fails too. Then you switch to residential proxies and it works. Most of us stop there, because if it works, we don’t touch it. But residential proxies are a specific architecture your scrapers run on, and picking one should be a deliberate choice based on parameters, not a lucky fix.

We start from the basics: how IP addresses are allocated and classified, and why a target can tell a home IP from a datacenter IP. Then we cover how a proxy routes your traffic, comparing HTTP/HTTPS and SOCKS5. From there we describe how a residential network is built, from gateway and orchestration to the exit node, and the main types: rotating, sticky, static and mobile. The last part looks at where exit nodes come from, the ethics of sourcing, and a decision framework for choosing a provider.

What’s inside

  • How DNS resolution behaves with SOCKS5 versus HTTP proxies using CONNECT, and what that means for DNS leaks
  • The three layers behind a residential provider: gateway, orchestration and exit node pool
  • Why rotating proxies break stateful sessions, and what happens to a sticky session when the exit node goes offline
  • Why carrier-grade NAT makes mobile IPs so hard to block, and the latency cost you pay for it

In the full article: The request flow step by step, the summary comparison table of residential proxy types, the breakdown of SDK and opt-in sourcing models, the ethical considerations in detail, and the decision framework for choosing a provider.

Read the full article on The Web Scraping Club